C&G 2921-31 Design and installation of domestic and small commercial electric vehicle charging installations.

Book Now

Key Details

  • Starts: 24 September 2024 at 9:00am
  • Duration: 2 days
  • Code: 5173
  • Available Places: 14
  • Cost: £350
  • Location: ETT

Overview

Level 3 Award in the Design and Installation of Domestic and Small Commercial Electric Vehicle Charging Installations (2921-31)

Itinerary

  • Day 1: 24th Sept 2024
  • Day 2: 10th October 2024 plus Short Answer Assessment & Online Exam

Alternative Dates

The UK is aiming to become net-zero by 2050. The transport sector is one of the UK’s largest emitters of CO2 and a major source of air pollution in cities. Decarbonizing transport is, therefore essential if the UK is to meet its goal of net zero emissions by 2050, one of the primary drivers enabling this strategy is through the Electric Vehicles. Sales globally for Electric vehicles have significantly increased over the last 3 years. The result of more electric cars on the road requires an infrastructure in place for car users to charge their vehicles at their convenience.

Course Overview

This course will give you the technology specific knowledge that is required to install Electric Vehicle Charging Equipment with confidence.
  • Introduction, BS 7671 section 722 and the current IET Code of Practice
  • Modes of charging, EV Supply Equipment, restrictions
  • Installation practices, risk assessment, earthing, protection, labelling
  • On street and small commercial situations
  • Inspection, testing, fault finding & maintenance
  • Certification & notification to DNO

Entry Requirements

We cannot accept any registrations for candidates under 18 as these qualifications are not approved for under 18s.  This course is intended for practicing electricians.  Learners must hold one of the following:

  • City & Guilds Level 3 NVQ Diploma in Installing Electrotechnical Systems and Equipment (Buildings, Structures and the Environment) (2357)
  • City & Guilds Level 3 NVQ Diploma in Electrotechnical Services (Electrical Maintenance) (2357)
  • City & Guilds Level 3 Electrotechnical qualification (5357)
  • City & Guilds Level 3 NVQ in Electrotechnical Services Experienced Worker (2356)
  • City & Guilds Level 3 Electrotechnical Experienced Worker Qualification (2346)
  • Placeholder for City & Guilds Level 3 Electrotechnical in Dwellings Experienced Worker Qualification (2347)
  • Other Awarding Organisations equivalences will also be acceptable
  • Equivalent historical qualifications (see EAS Table 4B/4C on latest version)

or

• ECS Gold Card, JIB Electrician or Approved Electrician Card

For qualifications achieved outside of the UK, refer to the section Qualifications from outside the UK in the EAS Qualifications guide August 2023 (theiet.org).

The qualifications above must have been achieved no more than 5 years prior to starting this qualification or there must be evidence the candidate has remained current by completing relevant CPD such as a City and Guilds 2382 or equivalent.

Exams & Assessments

  • Online multiple choice
  • Short answer question paper and scenario-based questions

Course Materials

On attendance of the course, you will need the following:

  • IET Code of Practice for Electric Vehicle Charging Equipment Installation (5th Edition)
  • IET On-site Guide 18th Edition A2:2022
  • IET Wiring Regulations 18th Edition A2:2022
  • IET Guidance Note 3: Inspection & Testing – A2:2022

 

 

Book Now

Price Qty
Online Bookingshow details + £350.00 GBP  

Course Enquiries

If you have an enquiry regarding this course, please contact us using the form below.

"*" indicates required fields

Agree to Terms and Privacy Policy?*
By submitting this form, we will process your data in accordance with our Privacy Policy. You may withdraw this consent at any time by emailing us.